xxarmedforcesxx
New member
hello everyone, I recently just sold a neon that I have been building for 3 years. I thought that if I used upper compression ratio pistons, port/polishing my head and intake, made a higher lph on fuel pump and open the cfm on my throttle body, fidanza adjustable timing, light weight everything, removed all emisions, etc that it would make that car awesome in a quarter mile. Well I was wrong, I should have listened. The neon was pushing 12 to 1 compression ratio running turbo blue with out the nitrous and this car would smoke like crazy when it was first fired up. I decided on using the r/t transmission and for all to say the neon was impoved but not anywhere close on what I wanted. So I SOLD IT!
I bought this 1999 tiburon. As I look at stats on this car it would be really impressive to make this car into a quarter mile car but I have no clue about import vehicles. I was always a dodge and chevy fan. I got the idea to turbocharge the engine and run a nitrous oxide system to remove lag and that the nitrous will shut down when the turbo starts pushing 15 psi of boost but i really dont know if that is enough. My question is for the beta1 2.0 liter G4GF engine. I have a hard time finding any parts made for this engine and it has been very confusing. Does anyone know where should I check out to get a good set up for my internals? What would be the best material to use? IE/ Aluminum 2320. Should I do a complete engine swap? If so what motor will work for this model?
I bought this 1999 tiburon. As I look at stats on this car it would be really impressive to make this car into a quarter mile car but I have no clue about import vehicles. I was always a dodge and chevy fan. I got the idea to turbocharge the engine and run a nitrous oxide system to remove lag and that the nitrous will shut down when the turbo starts pushing 15 psi of boost but i really dont know if that is enough. My question is for the beta1 2.0 liter G4GF engine. I have a hard time finding any parts made for this engine and it has been very confusing. Does anyone know where should I check out to get a good set up for my internals? What would be the best material to use? IE/ Aluminum 2320. Should I do a complete engine swap? If so what motor will work for this model?