Marc07
Road Burner
Hello Guys
I know very little about sport/performance air filters, just basics really, but I'm seriously thinking of installing one. I've read the Air Filters article and to be honest everything is against me.
Engine: V8 3.7 40v / 280 BHP
Bad points:
- engine produces ridiculous amount of heat
- lack of space in engine bay
- ??air flow sensor just by the air box ??? some one told me that if I take the air box out and put the cone filter in it's place, then it could effect me in some bad way, but not explained exactly what wrong can happen, with cone filter I will get more air flow and sensor being just by the filter my register to much air something ????
Thats the filter I was thinking about
Thats the link to DT website where I found it, if you click on 'Foam Top Dimensions' just under the picture you will get all the data.
http://www.demon-tweeks.co.uk/Motor...op_Rubber_Neck_Universal_Air_Filter/1689/3257
Can't remember no what wax exactly the diameter on the end of the pipe, nut it was either 85mm or 90mm, so from that table looks that filters diameter will have to be the 150mm and the lenght/height of it 200mm.
I'm planning to put a chip as well together with the filter to achieve the magic 300+ BHP (310BHP -ish to be precise),
All your help and knowledge is very much appreciated.
Regards
Marc
I know very little about sport/performance air filters, just basics really, but I'm seriously thinking of installing one. I've read the Air Filters article and to be honest everything is against me.
Engine: V8 3.7 40v / 280 BHP
Bad points:
- engine produces ridiculous amount of heat
- lack of space in engine bay
- ??air flow sensor just by the air box ??? some one told me that if I take the air box out and put the cone filter in it's place, then it could effect me in some bad way, but not explained exactly what wrong can happen, with cone filter I will get more air flow and sensor being just by the filter my register to much air something ????
Thats the filter I was thinking about
Thats the link to DT website where I found it, if you click on 'Foam Top Dimensions' just under the picture you will get all the data.
http://www.demon-tweeks.co.uk/Motor...op_Rubber_Neck_Universal_Air_Filter/1689/3257
Can't remember no what wax exactly the diameter on the end of the pipe, nut it was either 85mm or 90mm, so from that table looks that filters diameter will have to be the 150mm and the lenght/height of it 200mm.
I'm planning to put a chip as well together with the filter to achieve the magic 300+ BHP (310BHP -ish to be precise),
All your help and knowledge is very much appreciated.
Regards
Marc