I’m performing a fairly common engine swap to an MG Midget with a rover 1.8 k series engine. Although common, this swap is slightly different - my engine is a turbo’d version (from 55bhp to 200bhp - weekend track use only). Old school engine guy, I know little about turbos. With the limited engine bay area - I’m wondering if I can customize the exhaust manifold /turbo to fit better rather than make changes to chassis/drive train. So my question: Can the exhaust manifold/turbo be refabricated to fit better is the engine bay? What should I look out for in terms of potential issues? Seems like there are custom kits around that allow the exhaust manifold/ turbo to be customized to fit do so, just don’t know much about them.