I have found some parameters for the lambdasensor:
At lean mixture: 200-450 mV
At rich mixture : 550-800 mV
Ideal would be: 500 mV , but it always goes up and down. Should be in that range..
You have a 4-pin stekker. For this test you should measure between pin #1 and pin #2.
Those are...
Hi there.... damn.. that's no luck so far..
I would suggest replacing the slave unit (its the hydraulic pressure bearing for clutch engagement/disengagement?) now you've got the gearbox off.
Replacing it afterwards is a struggle...
1) Ohm-readings I'll have to check somewhere... I'll let...
You guys have the 33 mixed up with the 75 :)
The 33 is FWD with a boxerengine placed in driving direction with the
Gearbox straight behind it.
The 75 is RWD with either a TS engine or Nord engine, both placed in driving direction.
Then you get a center driveshaft witch leads to the...
You could fit an 1.7 16V qv engine in there...
You'll gonna need the ecu and engine wiring loom aswell..
Also don't forget the airflow meter (inbetween the airfilter and intake manifold)
But I assume if you look for an engine, you'll keep in mind
that the engine is complete with manifolds...
Normally the software being used is called: examiner, but this software
can't be used on a regular notebook without a special VCI module..
Don't know how to get a hold on that one
I think your software should do the trick ;)
Good luck and keep us posted :P