Torque Cars

I'm an idiot and I hope you lovely lot will help me anyway.

Discussion in 'Engine questions' started by DomCrowley, 7 June 2018.

  1. DomCrowley

    DomCrowley New member

    I'm a student :(
    *I hope this thread is in the right place*

    Sooooo, I went and bought a c35a (Honda 3.5 v6) since it was only a tenner, I've never really worked on engines before but I like getting thrown in at the deep end. I'd like to think I have alright knowledge of engines considering the above.
    The question really is: what does it take to get an engine running?
    I've stripped almost the whole thing down and have inspected all the major components other than the crank and they seem fine other than a small amount of surface rust in one of the cylinders.
    The wiring harness is there but no ECU, it also has the starter, alternator and power steering pump as well as the water pump, fuel rails and Coil on plug spark caps (not sure if thats the right term)
    I've had a good look around the internet and can't seem to find any posts like this so hopefully this could be a good help to any other idiots in my position.

    Thanks in advance,
    Dom x

Share This Page

Click Here
  1. This site, like pretty much every other site, uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are agreeing to our use of cookies, this may include third party cookies from our carefully selected advertising partners and for our analytics which allow us to see which pages are of interest and improve our site navigation and experience.
    You can disable cookies in your browser but this may affect your experience on this website.

    Dismiss Notice