Recent content by speedy

hi, ive got a problem with my polo, it starts but wont rev. ive had a vag-com reader on it and it came with these codes. 18047- Accelerator Position Sensor 1/2 18039- Acceleration Pedal Sensor (g79) Signal Too High 18042- Acceleration Pedal Sensor 2 (g185) Signal Too High 16497- Intake...

hi all, today i welded my exhaust up, simple job to do, i removed the exhaust from the manifold, welded it up, put it back on the car, fired her up an now the throttle wont open. ive checked for lose cables, wires. cleaned the senses an made sure everything was connected. ive had my mates...

the abs light comes on some times but then after a couple of miles to goes off. it does this about 2-3 times a week. i havent had a diagnostic test done yet

hi all my 1.0 polo 2000 reg. has had the epc light on for the past month. the car runs fine and the brake lights work and so do the back lights.. what could be the problem because ive got a mot in 2 months. thanks

would you be able to do it your self if you are a compentent welder? i have already needed to weld the rear arches an also the boot floor. also what would be the best remerdy for rust around the fuel filler cap. any suggestions would be great. thanks

hi all i have a 2000 ford ka and i have started to get holes in the sills. i have got some new ones. what is the best way off fitting them. thanks

ok. cool. ill try that and see if it helps. thanks

it is a wire arrengment

hello. i have a 1.3 ka W reg. it has started to make a quite grinding noise. this only happens when its in neutral with the clutch out. when you put the clutch in it stops. also when the engine gets to temp. an i come to change gear the engine revs its self after a couple of seconds it stops...

well. not much has happened due to the cost of insuring my daily run around. but with it being warmer an more hours in the day the prodject should pick up again i hope.:bigsmile:

or you could get a sealed battery at http://www.braillebattery.co.uk/

i have no idea why we disconnected the battery. it seemed a good idea. i have fixed the problem. it was the air flow metre that had gone.

hello. my mates 1.25 ztec is not running right. between 3500 revs an 4500 revs there is a flat spot. yesterday we disconnected the battery for about an hour while fitting a ice install. once fitted and connected back up. the problem arised. we've cheacked the earth cables. made sure...

red bull.:lol:

bodykits on corsas an saxos pointless. how ever on a skyline, 350z. nsx. subaru an others. look good. but they are there for a purpuse. bigger front grille aids in cooling. brake ducts to cool brakes an pervent brake fade. wide archs= bigger track width= better cornering speed, handlering an...