Push start button wiring ????

[dagger]

As I don't want to make this a mess, which wire goes where?


I need to know the following:


Off the Relay Box (for the button) - I have 4 wires

Black (Earth - I know this one

)

2 Blues

1 Red


.................................................................................................................................................


1 x Blue needs to goto Terminal 15 (ignition) behind the ignition switch - which colour wire does this fix to ??

1 x Blue needs to goto Terminal 50 (Power path from Ignition, to the starter motor ) - Again which wire ??

1 x Red to terminal 15 - power path that passes through ignition - which wire ??






Thank you

 

[davalav]

Wish I could help, but I am useless with wiring! 'm sure you'll work it out!

Isn't there a diagram or anything?

 

[Dr Acula]

Easy way is to connect a FUSED wire to any ign feed fuse,that will carry the current, then run said wire to one connector on back of push button switch.Then run another wire , from other switch terminal, to rear of starter and remove the wire at the back of solenoid (comes from ign barrel) and attach new wire.Bish Bosh job done and easy to return to standard if need be as yo just reconnect the original wire if you encounter a problem or wish to sell it. Might be a good idea to tape over end of removed wire as a precaution.:bigsmile: