Recent content by Wcnwzrd

Thanks for the replys Herb, Wizzer. It was the starter just never heard/felt anything like that before from a starter in any of my vehicles.

Hey guys, I know it has been a bit since the last time I was on but have a question that I need an answer to pronto. My daily is down for a major repair and was using my backup until earlier today. Went to start it and starter/solenoid stayed engaged even after returning the key to "ON"...

Hey everyone, I'm back again. Sorry for the long break. Been going through a divorce and setting a lawsuit from my ex-inlaws, yippee right. Not sure if this is where this should go but since it concerns a Chevy figured this was the best stop. Feel free to move it as needed. OK, so i have a 97...

we have Craigslist here in the states, great place to search as it is free to post but have to be careful and know what you are looking at. Second for me is Autotrader then Cardomain. Quite a few people put up full sets of pics on the mods they do so you can see if they did it right or not.

I get between 300 and 350 US miles but that is with a 30Gal tank. Usually only fill up if going on a trip other than that put in just enough to get the work done for the week.

He will have 100% solitude alright. Solitary confinement on the couch. LOL

Hey all. I have a 1995 G30 van that has been used as a utility vehicle for the better part of its life. I just recently did a partial tune-up do to this issue and was hoping you all could potentially point me to one of a group of parts that I think might be causing the issue. Issue: After 30 to...

No problem. I do a ton of radios and always seems like they find new ways to make it hard to install an aftermarket stereo. Just be glad you don't have a Mazda3 as you would have lost a ton of your gauges/info unless you buy an aftermarket adapter for them.

Pop off plastic dash piece using a flat head screw driver. (Look on bottom for slots and carefully pry off. You should be able to just set this piece on the dash and leave all wires connected) Once done, you should see 4 screws holding factory stereo in. Remove. Carefully remove factory stereo...

used to have a chia-pet attached to the center console in my datsun.

First Off, we need to get that guy to a shrink fast and second, somebody please just crush that car and put it out of its misery.

Agree with above. We have stuff here called goo-gone/gunkoff that works well but not sure if you can get it in the UK. You will need quite a bit of elbow grease in the wash to make sure that you get everything off prior to waxing. Also double/triple inspect as getting dirt off once you wax is a...

Answered this in ICE forum. Please try not to spam the forums. Reply to the original or only post in one spot. The mods here are pretty good at making sure they get put in the correct forum if you are unsure. Most of us just log on and click "New Posts" anyhow so we will see it.

Most factory stereo units come with just enough hookups for the speakers/outputs that are installed at the factory. If you already have subs/amps then you will be fine, otherwise you will be needing a new one but you can get a decent entry level system for pretty cheap nowadays.

I would suggest putting matting down and ensuring it was completely sealed and then it might sound decent. Bass tubes would be a better way to go if you are thinking space (as your other post suggests) Put one on either side and you can put all your shopping/gear in between. Just make sure they...