TorqueCars car forums - View Single Post

**pgarner** · 24-05-2010, 10:22 PM

nope its a 2 min job.
remove headunit
locate the red and yellow wires and swap them

mulitmeter on the 2 wires to find what one is ignition, if its not written on it
cut the ignition wire
strip both ends (make sure the ignition is off)
wrap the remote wire into one end of the wire
add a terminal block ( 5 amp one will do cost about 50p for a strip of 12 from a decent hardware store)
put the other half of the wire in the other side
tighten up both screws
wrap in insulating tape - for additional protection

24-05-2010, 10:22 PM	#21 (permalink)
pgarner Super Moderator TC Founder Car: Octy smoke machine Join Date: Jul 2007 Location: Lockerbie, SW Scotland Posts: 15,726	Re: Wiring nope its a 2 min job. remove headunit locate the red and yellow wires and swap them mulitmeter on the 2 wires to find what one is ignition, if its not written on it cut the ignition wire strip both ends (make sure the ignition is off) wrap the remote wire into one end of the wire add a terminal block ( 5 amp one will do cost about 50p for a strip of 12 from a decent hardware store) put the other half of the wire in the other side tighten up both screws wrap in insulating tape - for additional protection _______________________________________________ Octy Oil Burner